Bosch VCD Series Installation Manual page 118

118 en | Configuring the HD Conference Dome
CAUTION!
You can specify limitations for overwriting older recordings in
Continuous mode by configuring the retention time (see
Section 12.34 Retention Time, page 119).
Standard profile
From this field, you can select the encoder profile to be used
for recording (see Section 12.19 Encoder Profile, page 97).
NOTICE!
The recording profile can deviate from the standard setting
Active profile and is only used during an active recording.
Pre-alarm Time
You can select the required pre-alarm time from the list field.
Post-alarm Time
You can select the required post-alarm time from the list field.
Post-alarm profile
You can select the encoder profile to be used for recording
during the post-alarm time (see Section 12.19 Encoder Profile,
page 97).
The Standard profile option adopts the selection at the top of
the page.
Export to FTP
Select this parameter if you want to use the Export to FTP
function on the RECORDINGS page (see Section6.8The
RECORDINGS Page, page103). Make sure to have inserted all
relevant data for FTP posting (see Section5.41Advanced Mode:
FTP Posting, page88).
Alarm input / Motion alarm / Video loss alarm
Here you can select the alarm sensor that is to trigger a
recording.
Virtual alarm
Here you can select the virtual alarm sensors that are to trigger
a recording, via RCP+ commands or alarm scripts, for example.
F.01U.265.806 | 1.0 | 2012.03 Installation Manual
HD Conference Dome
Bosch Security Systems, Inc.