Table of Contents
Advertisement
HD Conference Dome
CAUTION!
The profiles are rather complex. They include a large number of
parameters that interact with one another, so it is generally
best to use the default profiles.
Change the profiles only once you are fully familiar with all the
configuration options.
In the default setting, Stream 2 is transmitted for alarm
connections and automatic connections. Bear this fact in mind
when assigning the profile.
NOTICE!
All parameters combine to make up a profile and are dependent
on one another. If you enter a setting that is outside the
permitted range for a particular parameter, the nearest
permitted value will be substituted when the settings are
saved.
Profile name
You can enter a new name for the profile here. The name is then
displayed in the list of available profiles in the Profile name
field.
Target data rate
You can limit the data rate for the HD Conference Dome to
optimize utilization of the bandwidth in your network. The
target data rate should be set according to the desired picture
quality for typical scenes with no excessive motion.
For complex images or frequent changes of image content due
to frequent movements, this limit can be temporarily exceeded
up to the value you enter in the Maximum data rate field.
Maximum data rate
This maximum data rate is not exceeded under any
circumstances. Depending on the video quality settings for the
I- and P-frames, this fact can result in individual images being
skipped.
Bosch Security Systems, Inc.
Configuring the HD Conference Dome | en
Installation Manual
F.01U.265.806 | 1.0 | 2012.03
99
Advertisement
Table of Contents
