Table of Contents
Advertisement
20
HOW TO POWER ON
After connecting your XK-3 to the power outlet, please perform the following steps before switch-
ing on the power. To avoid possible damages to speakers, please do not change the order of the
steps.
BACK-UP
RESET TO THE INITIAL STATUS
POWER ON
STEPS TO TAKE
1.
Set the MASTER VOLUME Knob at 0 (minimum), before switching the power on.
2.
Switch on the POWER on the rear panel. "PLAY" Mode appears, following the TITLE, in the
Display window.
It takes a few seconds before the XK-3 gets ready, because of the circuit-protection
devices.
It requires 10 to 20 seconds to warm up the tubes to get ready, when the [TUBE
AMP] Button is ON.
3.
Switch on the power of the amplifiers etc. connected to the XK-3.
4.
Holding down a key, adjust the MASTER VOLUME by turning the Knob.
5.
Adjust the volume of the amplifiers etc.
Reverse the above steps when you switch off the power. (Switch off the power of
the amplifiers etc. first.)
Your XK-3 memorizes the setting of the keyboard immediately before it is switched off. So, The
keyboard will start with these settings when it is switched on again. This is called "Back-up".
The XK-3 is initially shipped from the factory with the Preset Key [B] in "pressed" status.
The Preset Key [B] does not produce sound when initially first turned on. Draw the
left Drawbar(s), or press either of the Preset keys [C#] - [A] to start.
Please perform the following steps to reset the XK-3 to the initial default setting.
STEPS TO TAKE
1.
Switch off the power of the XK-3.
2.
Holding the [REC/JUMP] Button, switch on the power.
3.
Hold down / Keep pressing the [REC/JUMP] Button until "Loading Default..." appears on the
Display.
4.
If everything is in order, PLAY Mode appears on the Display. (Completed)
Owner's Manual
Advertisement
Table of Contents
Troubleshooting
