Table of Contents
Advertisement
INTRODUCTION
Basic Hook-Up
All connections are found on the Accessory Panel on the back of the XK-2.
AC IN
POWER
ON
120V~
120V~
Ë A.C. Power
Your Hammond XK-2 is shipped from the factory set for 120 V.A.C. power. To connect the XK-2 to A.C. power:
1.
2.
3.
Ë Audio Connections
In order to hear the sounds produced by the XK-2, you will need to connect it to an amplifier or other external sound source.
You can either:
1.
2.
Connecting to an Amplifier
1.
2.
NOTE: At this point it is assumed that you are using a keyboard or guitar amplifier that has
assume this since this is the most common type of connector used on these types of amplifiers.
3.
If your amplifier has only a single (1) female
the L/MONO audio output connector on the XK-2, and the other end to the female
your amplifier.
LESLIE 11-PIN
PHONE
L/MONO
R
OUTPUT
Locate the A.C. Power Cord that came with your XK-2.
Plug the female end of the Power Cord into the receptacle on the XK-2 marked, "AC IN."
Plug the other end of the Power Cord into an A.C. power outlet.
Connect the XK-2 to an amplifier, or;
Connect the XK-2 to a Leslie Speaker cabinet.
Use two audio cables with
Connect one end of each of the audio cables to the audio output connectors on the back of the XK-2.
Connect the other ends of each cable to the female
USE HAMMOND
TREBLE
BASS
EXP-100 ONLY
L
R
TONE CONTROL
INPUT
1
/
" plugs on both ends of each cable.
4
1
/
1
/
" phono plug audio input, you can connect one end of one cable to
4
THRU
OUT
IN
MIDI
1
/
" phono plug inputs. We
4
" audio input connectors of your amplifier.
4
1
/
4
Hammond XK-2 Quick Features Guide
Introduction
1
EXP.
FOOT SW.
PEDAL
REV = < NORM
" audio input connector of
Advertisement
Table of Contents
