Sets Of Drawbars And Parts; Match The Registration To Drawbars - Hammond XK-3 Owner's Manual

36

3 SETS OF DRAWBARS AND PARTS

On this keyboard, there are 3 Parts: UPPER, LOWER and PEDAL, and each of them has the
corresponding Drawbars.
The manual on the keyboard is usually assigned to the UPPER position. If you want to play
the LOWER or PEDAL Part, use the Split or Manual Bass functions, or connect the MIDI
keyboard and assign each part.
There are lamps(= LED's) in front of the two sets of 9 Drawbars, marked with "UPPER/ B"
and "LOWER/A#". They indicate the assignment of the Drwabar Sets. They are assigned to
UPPER and LOWER when shipped from the factory.
A# and B are used when you want to operate it like the Upper Manual of the B-3/C-3. In this
case, both Drawbar Sets correspond with the Preset Key A# and B, and control only the
UPPER Part. The LOWER Part is not controled. Please read the CONTROL Chapter for
further details. (P. 58)

MATCH THE REGISTRATION TO DRAWBARS

If you recall the Combination Preset, the Drawbar Registration is not physical but is
replaced with the recorded/memorized one. If you move any Drawbar at this stage,
only the Footage moved is reflected.
To match only the Registration to the Drawbars, while using the content of the Combi-
nation Preset, keep depressing the Preset Key for a while. Combination Preset is
recalled and then the physical Drawbar Registration is reflected.
Touch and Hold
Owner's Manual