Zones - Hammond XK-3 Owner's Manual

84
To control the external sound module, a certain range of
the manual keyboard of this keyboard is used for that.
Each of them is called the "EXTERNAL ZONE". At
the same time, you can set the oscillating range (=
"INTERNAL ZONE") of the built-in sound engine and
play on the same single keyboard.
6 7
1
2
INTERNAL ZONE
1. PEDAL
2. LOWER & UPPER - LOW
3. LOWER & UPPER - HIGH
This is for setting the playing range of each part of the built-in
sound engine by the keyboard.
Set the lowest note at LO and the upper most note at HI. The
upper most function of the manual bass is set at PED.
4. SPLIT POINT
If you use the Split function, set the KEY on where to split the
LOWER and the UPPER Parts on the keyboard.
The setting value is the highest note used in the LOWER Part.
NOTE: You can come to this mode by holding down the [SPLIT]
button as well.
NOTE: For 1 to 4, you can set the value by touching the [REC/
JUMP] button, while holding down a note on the
keyboard.
5. LOWER OCTAVE
This is for setting the pitch of the split LOWER Part by the
octave.
If you use the SPLIT function, the pitch of the LOWER Part
may go down too low for the harmony play. In that case, you
can move up the Lower octave upto the pitch suitable for
harmony play.
8
3 4
Owner's Manual

ZONES

To come to this mode:
Touch the [MENU/EXIT] button to display the MENU,
select PAGE D by the [PAGE] button, and then touch [1]
ZONES.
9 10 11
5
EXTERNAL ZONE
6. MIDI CHANNEL
This is for choosing the MIDI channel to send to the External
Zone.
The range is 1 - 16 and OF. At 0, no sending to this Zone.
7. MAP - LOW
8. MAP - HIGH
This is for setting the playing range of this zone on the
keyboard.
NOTE: For 7 and 8, you can set the value by touching the [REC/
JUMP] button, while holding down a note on the
keyboard.
9. PROGRAM - BANK MSB
10. PROGRAM - BANK LSB
11. PROGRAM - BANK PROGRAM CHANGE
This is for setting the Bank Select and Program Change to send
to this Zone.
Generally, the tone of the synthesizer or the Sampler is
switched by the Bank Select and the Program Change. There
are such models as do not receive the Bank Select. The
receiving range is different from equipment to equipment.
You can choose 0 - 127 in the Bank MSB and the Bank LSB,
and 1 - 128 in the Program Change.
12. NOTE - OCTAVE
This is for moving the octave to send to this zone. You can set
the pitch to be sent to the key by the octave, if the desired
range is different from that prepared by MAP LO/HI.
12 13 14 15