Mirrorcopy Step-By-Step; Clevercopy Mode - Logicube SuperSonix User Manual

CLONING MODES AND SETTINGS
28

MirrorCopy Step-by-Step

1. From within the Settings menu tap
2. Select the optional preferences Speed and
3. Tap the Percentage icon
4. A screen will appear asking you to enter a
5. Tap YES to set the percentage to the
6. Tap
7. The Logicube SuperSonix will notify you

CleverCopy Mode

This mode is recommended for Master drives with
only FAT16, FAT32, or NTFS partitions. It clones all
partitions on the Master drive to the Target drive
and automatically sets the fastest method possible
for each partition.
Direction and alter them as needed using
their respective icons.
1. NOTE: See the Optional
Preference Settings section of
this chapter for more information
on these preference settings.
percentage of the Master drive to be
mirrored.
percentage of the Master drive to clone. Use
the electronic keypad to adjust the value
between 1 and 100% and tap OK.
1. NOTE: A User Attention
Required message will appear
asking: Do you want to set to
XX% mirror copy?
requested value. Tap NO to cancel this step
and go back to the previous screen.
(Start) to begin the cloning
process.
when cloning has completed. You will see a
message that reads Clone Successful!
Drive cloned successfully! along with the
maximum speed that the transfer process
obtained. Tap and hold down the STOP icon
at any time to stop and cancel the cloning
process.
Logicube SuperSonix User's Manual
.
to set the