Logicube SuperSonix User Manual page 23

Logicube SuperSonix User's Manual
CLONING MODES AND SETTINGS
7. Insert the USB flash drive into the SAS
adapter USB port.
8. Insert the power supply cord to power the
SuperSonix.
NOTE: The remaining steps provide an example of
how to update just the BIOS but they are also
applicable for updating Firmware, Kernel and
Software.
9. Tap:
10. Enter the password [logicube] in lower case.
11. You will be prompted to enter a revision
number. In this example it is the current
BIOS revision number. (This and all current
revision numbers are provided in the
readme.txt file that accompanied the
previously downloaded update files. As of
this writing the value for Bios Revision is
150. Entering an incorrect revision value will
cause the process to error out.
12. Enter the current revision for the respective
item you are updating. If the revision number
matches the excepted number the update
process will begin automatically.
NOTE: It is imperative that power be maintained
throughout the SAS adapter update. Do not remove
power to the SuperSonix until the update process
has completed.
NOTE: The SAS adapter must be upgraded to
software version V304 and the SuperSonix must be
at or upgraded to software version V1.70 in order
for the SAS Adapter to work correctly. Refer to
Section 8: Software Loading Instructions for
SuperSonix software loading instructions.
NOTE: Please refer to Section 5: Optional
Peripherals for information regarding use of the
optional SAS adapters.
23