Usb - Strong SRT 7000 User Manual

PART 1 • English

7.7 USb

Press MEnU and select USB. The menu provides Multimedia feature to playback Music, Photo, Movie and
with the receiver Recorded files. Supported are different file formats listed below. In this menu you also
can see information about the total and free space of the connected USB device, make video and photo
configurations and format the USB device into the receiver accepted format. The unit supports USB
devices with FAT and FAT32 format. Make sure your USB device is appropriate formatted; refer to point
7.7.4 Recording Configure for more details.
noTE: STRONG cannot guarantee compatibility (operation and/or bus power) with all USB
mass storage devices and assumes no responsibility for any loss of data that may occur
when connected to this unit.
With large amounts of data, it may take longer for the system to read the contents of a
USB device.
Some USB devices may not be properly recognized. Even when they are in a supported
format, some files may not play or display depending on the content.
7.7.1 Multimedia
If there is no USB device plugged in, a warning message "No USB Device is Found" will be displayed.
When an USB device is detected you can select between Music, Photo, Movie or Records in this menu.
Select one of them, press ok to enter the file browser and select the file you wish to be played.
Music – supported file formats are MP3 and WMA.
Photo – supported file formats are JPG and BMP
Movie – supported video files in various formats (MPG, MPEG, TS, VOB, MP4, AVI,...)*
Records – displays list of recordings.
Music
Select the desired music file and press ok to start playback.
During playback, the following functions are available:
PlAY (u) or ok: starts playback of the selected file.
2 to pause/resume playback and 3 to stop it.
5 and 6: to review or forward the playback with x2, x4, x8, x16 and x32 speed. If reviewing reaches the
beginning, it will resume the playback of the current file, and if forwarding reaches the end, the playback
of the next file will start.
goTo: opens a counter banner for entering the desired time moment you want to jump to. Use the 0~9
buttons for entering the time and ok to confirm.
7 and 8: starts playback of the previous/next file.
REPEAT: Press once for single file repeat, twice to repeat all files or triple for random playing. The symbol
for selected repeat mode will appear at the top of the screen. Press once again to return to common
play mode.
RECAll: goes to the up folder.
EXIT: to get back to the Multimedia menu. Press EXIT once more if want to leave the Multimedia menu.
TIP: Playback of music will continue as long as the Multimedia menu is active. This allows
you to listen to music while watching photos. Just exit of the Music submenu and select
desired slide mode in the Photo submenu like explained below.
17