Strong SRT 7000 User Manual page 19

Software update
In Main Menu select Software Update and press ok or u to select. There are two software update
options available:
SW update by oTA
The OTA (Over the Air) function allows you to search for software updates available on satellite. Please
ask your local STRONG dealer or visit our website http://www.strong.tv for according information.
In the OTA menu all necessary STRONG OTA settings (Satellite, Frequency, Symbol rate and Polarization)
are already set per default but could also be changed manually. Press ok to initiate the update process.
An attention banner will now be displayed. Press ok to start the update (or EXIT to cancel it). Follow
the instructions displayed on screen. The software searching and update process could take up to 20
minutes depending on the data volume in stream. After process is finished (also if no Update was
found) receiver will reboot and start with the last shown channel.
WARnIng: nEvER power off the receiver or pull the mains plug during the software upgrade
process. Doing so might cause irreparable damage to your receiver and will void
your warranty.
SW update by USb
Download the required update file for your receiver model from our website http://www.strong.tv
support page or contact your local dealer.
Unzip file, if necessary, and copy it to root folder of your USB storage device.
Connect USB storage device to the USB port of the receiver. Press MEnU and select Software Update By
USB. Press ok to enter the software file list. Select the file with software image and press ok to initiate
the software update. An attention banner will now be displayed. Press ok to start the update (or EXIT to
cancel it). Follow the instructions displayed on screen. Update process will take some time. Once update
is completed the receiver will display message "Software Upgrade Complete. Please Restart". Unplug the
receiver from the mains and plug it in again. Your updated receiver will start with the last shown channel.
WARnIng: NEVER power off the receiver or remove the USB device during the software update
process. Doing so might cause irreparable damage to your receiver and will void
your warranty.
Auto Standby
Auto Standby is a new, power saving feature that helps you with reducing power consumption. It will
switch off the receiver when no command is given for the defined period of time. It's set per default to
180 Minutes. With the tu buttons you can select between different time intervals or Off for disabling
the feature. In the 0000 Mode you can enter the desired Auto Standby time by using the 0~9 buttons.
noTE: If there are Timers running, the Auto Standby function will be disabled for the booked
time, so that the records can be full finished. But in case of Instant Recording (REC
button) the Auto Standby function has priority.
16
PART 1 • English