Strong SRT 7000 User Manual page 16

PART 1 • English
After configuring press ok or blUE again to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with scan progress shown on screen. During
channel search you can skip Transponders by pressing MEnU button, or quit the scan process by EXIT.
Once the process is finished, all found channels will be stored and the receiver will switch to the first
found channel.
Multi-Satellites Scan:
Scanning by transponder (Manual Scan)
Press goTo for displaying the transponder list of the focused satellite. By pressing goTo again you
switch back to the satellites list.
Single Transponder Scan: Use pq buttons to highlight the transponder your wish to scan. Press blUE
Multi-Transponder Scan: Select the transponders you want to scan by ok button. The selected
7.3.1.4 Satellite Edit options
Add satellites:
Edit satellites:
Delete satellite:
7.3.1.5 Transponder Edit options
Add transponder:
Edit transponder:
Delete transponder:
When using a multi feed antenna with more than 1 LNB, select the satellites
your antenna is adjusted for by ok button. The selected satellites will be
marked by the symbol "z". Set in the DiSEqC point the appropriate LNB
numbers and press blUE for Scan. A window with scanning settings will be
displayed. After configuring the settings like explained in Single Satellite Scan
above, press ok or blUE again to start Multi-Scan on all selected satellites.
for Scan. A window with scanning settings will be displayed. After configuring
the settings (explained in 7.3.1.3 above), press ok or blUE again to start
scanning on focused transponder. Once the scan process is finished, all found
channels will be stored and the receiver will switch to the first found channel.
transponders will be marked by the symbol "z". Press blUE for Scan. A
window with scanning settings will be displayed. After configuring the settings
like explained in 7.3.1.2 above, press ok or blUE again to start Multi-Scan on
all selected transponders.
Press RED to add a new satellite. In new opened menu enter the satellite's
name and position by using Navigation and Numeric buttons. In the appeared
key table select a character by using the navigation buttons. Press ok to
choose the character. Once you finish inputting the new name, navigate to
"OK" button on screen and press ok on the remote control to confirm the
new name.
Save the settings with ok or cancel by EXIT.
Press gREEn to edit the focused satellite. For changing settings see
explanation above. Confirm changes with ok or cancel by EXIT.
Press YElloW to delete the focused satellite. Press ok to confirm deleting or
EXIT to cancel it.
Press RED to add a new transponder. In new opened menu enter the
transponder´s data by using Navigation and Numeric buttons. Confirm the
settings with ok or cancel by EXIT. An existing TP cannot be stored again
under the same satellite.
Press gREEn to edit the focused transponder. In new opened menu enter the
new transponder´s data by using Navigation and Numeric buttons. Confirm
changes with ok or cancel by EXIT.
Press YElloW to delete the focused transponder. Press ok to confirm deleting
or EXIT to cancel it.
13