Channel Search - Strong SRT 7000 User Manual

7.3 Channel Search

To access the menu press MEnU and select Channel Search. It contains two options: Installation and DB
(Data Base) Management. Select an option and press ok to enter it. Press EXIT to exit the menu.
7.3.1 Installation
7.3.1.1 Satellite Selection
Use pqbuttons to highlight the satellite your dish is aimed at. Its antenna settings will be shown at the
right side. You can enter the right side with tu buttons and return to the satellite list with EXIT.
7.3.1.2 Configure the antenna settings for selected satellite
LNB Type:
LNB Power:
22 kHz:
Toneburst:
DiSEqC1.0:
DiSEqC1.1:
Motor:
DiSEqC1.2:
Move Continue:
Move Step(1):
Store Position:
Goto Reference:
GOTO X:
Set Limit for DiSEqC1.2 and GOTO X options:
For Move Continue, Move Step(1) and Goto Reference please see explanation above.
Set West Limit:
Set East Limit:
Disable Limit:
7.3.1.3 Channel Scan
Automatic Scan
Single Satellite Scan:
Scan Mode:
Default:
Blind Scan:
NetWork:
Crypted:
Service Type:
12
Press tu or OK to show the list of LNB Types which is shown as frequencies
of local oscillator. You also can enter frequency by User Single, User Dual at
bottom of the list. Default is set a Universal LNB (09750/10600) – the most
used on the market.
Press tu to set the LNB power. 13/18V is the setting for a Universal LNB.
Press tu to switch on or off the 22KHz oscillator signal. Auto is the setting for
a Universal LNB.
to enable or disable the toneburst switcher if available.
to select the right port from up to 4 (if available) for the right LNB.
to select the right port from up to 16 (if available) for the right LNB.
if using a motor press tu to select between DiSEqC1.2 or GOTOX depending
of motor type. Then Press ok to show the menu to set position or gREEn
for location.
Move the motor to the right position for locking the signal like explained below.
Press tu for moving West / East. It will keep moving as long as the button is
hold pressed. Once pressing will move in 1°step.
Press tu for moving West / East in 0.3° step.
to store the current motor position for selected satellite.
to go to the reference 0° position.
Set your location coordinates. Main German locations are preinstalled. Press
tu to select. If Manual selected use tu, UP/DoWn and nUMERIC buttons
to enter the right position. By pressing ok position gets stored and the motor
moves automatically towards selected satellite.
to store the current motor position as West limit.
to store the current motor position as East limit.
to disable West and East limits
Press blUE for Scan. A window with scanning settings will be displayed.
Press tu to select Default, Blind Scan or NetWork.
All in the memory stored transponders will be scanned.
Slow scan in 2 MHz step. It first scans the whole frequency band to get the
transponders which can be locked. After gathering all transponders, it scans
the transponders one by one to get the programs.
Network search will be performed – when a Network information is
broadcasted new switched transponders will be found and stored.
Press tu to select All Channels (scrambled and free) or FTA Channels (free to air);
Press tu to select ALL, DTV or Radio.
PART 1 • English