Tray, Absorber Assembly Removal - Epson Stylus PHOTO 2000P Service Manual

EPSON Stylus PHOTO 2000P

4.2.5 TRAY, ABSORBER ASSEMBLY Removal

1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Remove the Panel Unit. (Refer to Section 4.2.3.)
3. Remove the two screws (CBS, 3x6) securing HOUSING, PANEL, LEFT
to the front left part of the printer mechanism.
Pin
CBP (3x8)
HOUSING, PANEL, LEFT
Figure 4-12. HOUSING, PANEL, LEFT Removal
4. Remove the one screw (CBP, 3x8) securing HOUSING, PANEL, LEFT to
the HOUSING, SUB, LEFT.
5. Release the pin fixing HOUSING, PANEL, LEFT to the printer
mechanism, and then remove HOUSING, PANEL, LEFT toward the
front.
C A U T I O N When removing HOUSING, PANEL, LEFT, watch out for the
Stacker Assembly. Since the Stacker Assembly is fixed by
the Panel Unit and HOUSING, PANEL, LEFT, it will come off
as HOUSING, PANEL, LEFT is removed.
DISASSEMBLY AND ASSEMBLY
CBS (3x6)
Disassembly Procedures
6. Remove the two screws (CBS, 3x6) securing HOUSING, SUB, LEFT to
the printer mechanism.
7. Release the three hooks (two at the bottom and one in the front) fixing
HOUSING, SUB, LEFT to the printer mechanism, and remove
HOUSING, SUB, LEFT.
8. Remove the one screw (CBP, 3x6) securing PAPER GUIDE, LOWER to
TRAY, ABSORBER ASSEMBLY at the middle of the printer
mechanism, and then remove PAPER GUIDE, LOWER.
CBP (3x8)
ABSORBER,
WASTE INK, TRAY, ABSORBER
LARGE/SMALL
CBP (3x8)
Figure 4-13. TRAY, ABSORBER ASSEMBLY Removal
Revision A
Hook in TRAY,
FRAME, RIGHT
ABSORBER
SPACER, TRAY
PAPER GUIDE,
LOWER
89