Connecting The Device To The Mains Voltage; Switching On For The First Time: Installing The Software - Fujitsu CELSIUS M4 Series Operating Manual

Connecting the device to the mains voltage

The device is fitted with a wide voltage range power supply. This means you do not need
i
to set the nominal voltage manually for these devices. Therefore there is no switch
available for the voltage setting.
► Connect the power cable to the device (1).
► Plug the power plug into a grounded mains outlet (2).

Switching on for the first time: installing the software

If the device is integrated into a network, the user and server details as well as the network protocol
are required during installation. Contact your network administrator if you have any questions about
these settings.
When you switch on the device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
Once the installation has been started the device must not be switched off, unless the
!
installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents of the hard disk
must be completely restored (see chapter "Hard disk contents, restoring")
You may need the licence number for Windows during the installation. The licence number is located
on a sticker on your device.
A26361-K994-Z220-1-7619, Edition 2
Preparing for use
2
1
15