Removing A Smartcard Reader - Fujitsu CELSIUS M4 Series Operating Manual

System upgrades
► Side the carrier with SmartCard reader into the module for the SmartCard reader (1).
► Fasten the carrier with the screws (2) on both sides of the slide-in module.
► Install the module with the SmartCard reader in the same way as an accessible 5¼ inch drive
(see "Installing an accessible 5¼ inch drive").

Removing a SmartCard reader

► Remove the module with the SmartCard reader in the same way as an accessible 5¼ inch
drive (see "Removing an accessible 5¼ inch drive"). When you do so, make sure to re-install
the Weight Saver if you do not install a new drive.
1
► Remove the screws on both sides of the slide-in module (1).
► Slide the SmartCard reader out of the module (2).
74
2
1
2
A26361-K994-Z220-1-7619, Edition 2