Removing An Accessible 3½ Inch Drive - Fujitsu CELSIUS M4 Series Operating Manual

Removing and installing a 3 ½ inch drive (e.g.
MultiCard reader)
A carrier is needed to install a 3½ inch drive in a 5 ¼ inch bay. When this carrier is used,
i
the 3½ inch drive can be installed in the 5¼ inch bay instead of the Weight Saver or a 5¼
inch drive.
Removing an accessible 3½ inch drive
► Remove the carrier with the 3½ inch drive in the same way as an accessible 5¼ inch drive (see
"Installing an accessible 5¼ inch drive"). When you do so, make sure to re-install the Weight
Saver if you do not install a new drive.
1
► Remove the screws (1) on both sides of the carrier.
► Pull the 3½ inch drive out of the carrier (2).
A26361-K994-Z220-1-7619, Edition 2
2
System upgrades
1
2
69