Table of Contents
Advertisement
Getting started
Connecting the device to the mains voltage
Device
Connecting
Device
► Check the voltage setting.
► Connect the power cable to the device.
► Plug the power plug into a properly grounded mains outlet.
The device is fitted with a wide voltage range power supply. This means you
do not need to set the nominal voltage manually for these devices. Therefore
there is no switch available for the voltage setting.
Switching on for the first time: installing the software
Installing,
Installing,
Software,
Once the installation has been started the device must not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device is integrated into a network, the user and server details as well as
the network protocol are required during the software installation.
Contact your network administrator if you have any questions about these settings.
When you switch on the device for the first time, the supplied software
is installed and configured. Plan a reasonable amount of time for this,
as this process must not be interrupted.
You may need the licence number for Windows during the installation. The licence
number is located on a sticker on your device.
14
1
2
A26361-K1002-Z220-1-7619, edition 2
Advertisement
Table of Contents
