Installing The Mini Pcie Card; Installing The Pci And Pcie X1 Expansion Card - DFI TPC121 User Manual

Installing the Mini PCIe Card

1. Grasping the Mini PCIe card by its edges, align the card into the slot at an approximately 30
degrees angle. Apply fi rm even pressure to each end of the card until it slips down into the slot.
The contact fi ngers on the edge of the card will almost completely disappear inside the slot.
2. Push the Mini PCIe card down until the clips at each end of the latch lock into position. You will
hear a distinctive "click", indicating the card is correctly locked into position.
Clip
Chapter 3 Installing Devices
Chapter 3

Installing the PCI and PCIe x1 Expansion Card

1. The PCI and PCIe x1 slots on the riser card are used to install the expansion cards. To install
the expansion cards, you need to remove the mounting screws that secure the brackets to the
chassis then remove the brackets.
2. Remove these mounting screws and brackets, and then put them in a safe place for later use.
3. Insert the Expansion card with a bracket into the slot that is on the riser card. Replace the
screw you removed in step 2 to secure the bracket in place.
Clip
21
PCIe x1
Bracket
Note:
The Expansion card used in the illustration above may not resemble the
actual card. These illustrations are for reference only.
PCI
Mounting screw
Expansion card
www.dfi .com