DFI TPC121 User Manual page 44

Chapter 6
4. Slide the Panel PC through the hole until it is properly fi tted against the panel.
5. Position the mounting clamps along the rear edges of the Panel PC, fi tting them into the slits
that are around the Panel PC.
296.00
Slit for mounting the clamp
Mounting clamp
White plastic cap
6. The fi rst and second clamps must be positioned and secured diagonally prior to mounting the
rest of the clamps. Tighten the clamp's screw using an electric screwdriver until the white plastic
cap touches the panel. Do not over tighten the screws to prevent damaging the Panel PC. The
illustration below shows all clamps properly mounted.
44
Chapter 6 Mounting Options www.dfi .com