DFI TPC121 User Manual page 54

Graphics Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Chipset
Graphics Configuration
IGFX VBIOS Version 2137
IGfx Frequency 350 MHz
Primary Display [Auto]
Internal Graphics [Auto]
DVMT Pre-Allocated [64M]
[256M]
DVMT Total Gfx Mem
 LCD Control
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Primary Display
Auto When the system boots, it will auto detects the display device.
IGFX When the system boots, it will first initialize the onboard VGA.
PEG When the system boots, it will first initialize the PCI Express x16 graphics
card.
Internal Graphics
Keep IGD enabled based on the setup options.
DVMT Pre-Allocated
Select DVMT 5.0 Pre-Allocated (Fixed) Graphics Memory size used by the Internal Graphics
Device.
DVMT Total Gfx Mem
This field is used to select the graphics memory size used by DVMT mode.
Chapter 7 BIOS Setup
Chapter 7
Select which of IGFX/
PEG/PCI Graphics device
should be primary delay
or select SG for switch-
able Gfx.
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
54
LCD Control
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Chipset
LCD Control
Primary IGFX Boot Display [VBIOS Default]
SDVO-LFP Panel Type [1280x1024 48bit]
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Primary IGFX Boot Display
The options are VBIOS Default, CRT, EFP2, LFP, EFP.
SDVO-LFP Panel Type
Select SDVO panel used by the internal graphics device by selecting the ap-
propriate setup item.
Note:
EFP2 means HDMI, LFP means LVDS and EFP means DVI.
NB PCIe Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Chipset
NB PCIe Configuration
PEG Not Present
PEG-Gen X [Gen1]
[Enabled]
Enable PEG
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Select the Video Device
which will be activated
during POST. This has no
effect if external graphics
present.
Secondary boot display
selection will appear based
on your selection.
VGA modes will be sup-
ported only on primary
display.
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
Configure PEG B0:D1:F0
Gen1-Gen3.
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
www.dfi.com