Rj45 Lan Ports; Usb Ports - DFI TPC121 User Manual

RJ45 LAN Ports

LAN 1 LAN 2
Features
• Intel W82579LM Gigabit Ethernet controller
• Intel W82574L PCI Express Gigabit Ethernet controller
The LAN ports allow the system board to connect to a local area network by means of a net-
work hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu ("South Bridge Configuration" submenu) of
the BIOS. Refer to chapter 7 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 8 for more information.
Chapter 5 Ports and Connectors
Chapter 5

USB Ports

USB 1
USB 0
USB 2.0
USB 8
USB 9
USB 2.0
USB allows data exchange between your computer and a wide range of simultaneously acces-
sible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports (USB 0-1/ 8-9). The two
10-pin connectors allow you to connect 4 additional USB 2.0/1.1 ports (USB 2-3/ 10-11). The
additional USB ports may be mounted on a card-edge bracket. Install the card-edge bracket
to an available slot at the rear of the system chassis and then insert the USB port cables to a
connector.
BIOS Setting
Configure the onboard USB in the Advanced menu ("USB Configuration" submenu) of the
BIOS. Refer to chapter 7 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device. Re-
fer to your operating system's manual or documentation for more information.
29
USB 10-11
USB 2-3
10 9
N. C. Key
GND GND
+Data
+Data
-Data
-Data
VCC VCC
2 1
www.dfi .com