DFI TPC121 User Manual page 50

F71879 Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
F71879 Super IO Configuration
F71879
F71879 Super IO Chip
Restore AC Power Loss
[Power Off]
Watchdog Timer
[Disabled]
SuperIO Watchdog Timer
10
Serial Port 1 Configuration

Serial Port 2 Configuration

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Restore AC Power Loss
Off
When power returns after an AC power failure, the system's power is off. You
the Power button to power-on the system.
On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state where
you left off before power failure occurs. If the system's power is off when AC power
failure occurs, it will remain off when power returns. If the system's power is on when AC
power failure occurs, the system will power-on when power returns.
Watchdog Timer
Enable or disable Super I/O watchdog timer.
Chapter 7 BIOS Setup
Chapter 7
Restore AC Power Loss
help.
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
must press
50
Serial Port 1 Configuration to Serial Port 2 Configuration
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Serial Port 1 Configuration
Serial Port [Enabled]
Device Settings IO=3F8h; IRQ=4;
[Auto]
Change Settings
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
Serial Port 2 Configuration
Serial Port [Enabled]
Device Settings IO=2F8h; IRQ=3;
[Auto]
Change Settings
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Serial Port
Enables or disables the serial port.
Change Settings
Selects the IO/IRQ setting of the I/O device.
Enable or Disable Serial
Port (COM)
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
Enable or Disable Serial
Port (COM)
→ ←:
Select Screen
↑↓:
Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
www.dfi.com