Table of Contents
Advertisement
A tripped breaker will protrude or move from its set position indicating that the circuit has been overloaded. Turn
off the device(s) on the circuit, then reset the breaker by pushing in once or by returning a breaker switch to the
on position. If the breaker does not reset or if it resets and then trips again after the device is turned back on,
then a short circuit exists or your device may be damaged, overloaded, or faulty. Correct the problem and then
reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either the
breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
Switch and Breaker Panel
The switch and breaker panel is located on the console. The numbers shown above or below each switch in the
photo below correspond with the following descriptions provided for each switch:
Circuit Breakers – On the switch panel below the individual switches
1
8
1
Bilge Pump - Your 29 Super Sport is equipped with an automatic bilge pump and float switch. This 1100
gph pump is located in the bilge and is accessible via the hinged hatch over the aft bilge area.
The bilge pump is wired automatic to the battery and has a manual override located at the switch panel on
the console. The automatic float switches are wired directly to the Starboard battery terminals through
breakers or inline fuses.
Depressing the bilge pump switch to the up or forward position activates the bilge pump.
2
Navigation and Anchor Lights - Locate the Nav. light switch on the instrument panel. This is a 3-way switch
(forward, middle, back/aft) that functions as follows when you press the switch:
•
Forward position - Turns on the bow lights and the anchor light. This position will also
activate the red light in your compass.
o
o
•
Middle position – All lights are off.
Back/Aft position – Anchor light is on; the bow lights and gauge lights are off.
2
3
9
10
The circuit breaker is located at the helm next to the manual switches.
If you have Faria gauges on the dash panel, this function will illuminate the
gauge lights.
If the gauges were provided by the engine manufacturer (i.e., Mercury,
Honda, etc.), this switch will not illuminate the gauge lights. Instead, your
gauge lights will be illuminated when the ignition switch is turned on.
4
5
11
12
13
6
7
14
15
Advertisement
Table of Contents
