Starting; Before Starting The Engines; Starting The Engines; After Starting The Engines - Pro-Line Boats 29 Super Sport Owner's Manual

•
Decreasing the pitch will enhance acceleration and power at high loads.
•
Increasing the pitch will increase speed at light loads.
•
Decreasing the diameter will compensate for any loss of power at high altitudes.
•
Increasing the diameter results in higher efficiency at low speeds at the expense of top end speed
and acceleration.
Be sure not to over rev the engine when re-propping or engine damage could result. Operating your engine with
a damaged prop will decrease performance, increase fuel consumption, and may introduce undesirable handling
characteristics. The vibration caused by running a damaged prop could cause costly damage to your lower drive
unit.

Starting

Follow the information in your engine manual if it deviates from the following instructions.

Before Starting The Engines:

•
Ventilate all enclosed spaces.
•
Visually inspect the bilge for fuel and check for vapors.
•
Visually make sure that the propellers are clear of obstructions or swimmers.
•
Make sure that the engine cooling water intakes are submerged.
•
Lock the helm seat to face straight forward.
•
Attach the safety stop switch lanyard.

Starting The Engines:

Start the engine according to the instructions provided in your engine manual.

After Starting The Engines:

After your engine starts, make sure to observe a few basic rules to insure the engine is functioning properly:
•
Verify engine cooling water circulation.
•
Check the temperature gauge for the first few minutes to make sure the engine is warming
properly and not overheating.
•
Check for fuel, oil and water leaks. If any leaks are found, shut down the engines and make the
necessary repairs before continuing on with your voyage.
•
Follow the break-in procedures as recommended by the engine manufacturer for your engines.

Fueling

Certain precautions must be observed when fueling due to the explosive nature of gasoline.

Before Fueling:

•
Secure the boat to the dock with adequate moorings.
•
Turn off the engine and any equipment having spark-producing contacts.
•
Close doors and hatches so fumes do not enter boat.
•
Disembark all persons not necessary for the fueling operation.
35