Fuel Fill And Vent; Fuel Sender And Fuel Pick-Ups; Fuel Water Separators - Pro-Line Boats 29 Super Sport Owner's Manual

Located below the access pie installed
aft of the helm seat.
Port Engine
Fuel Pick-Up
Inspect all hose connections on a regular basis. You can access the other end of the fuel fill and fuel vent hoses
via the deck plate that is installed inside the compartment located starboard of the helm seat. This compartment
also contains the washdown hose.

Fuel Fill and Vent

The fuel fill is a stainless steel fitting labeled "Gas" or "Fuel"
and is located approximately amidships on the starboard
gunwale. Twist the cap to open the fitting. The cap is
connected to the fitting by a chain or cable so that it will not
fall into the water and/or get lost. Be careful not to pump
fuel into any other fitting on the vessel.
The external fuel vent is located below the fuel fill on the
outside of the hull, and the gas tank is vented overboard.
While you are filling the tank, fuel entering the tank pushes
air in the tank out through the fuel vent.
Note: Never pump fuel into any fitting, opening or access on the boat unless it is labeled "Gas" or
"Fuel".

Fuel Sender and Fuel Pick-Ups

The fuel sender is accessible via the access pie that is installed forward of the helm seat and aft of the console.
The fuel pick-ups are accessible via the access pie that is installed aft of the helm seat.
The fuel sender is equipped with a float that moves up and down with the fuel level in the tank. The fuel level
information is sent to the fuel gauge and keeps you informed of the approximate fuel level in the tank. If you feel
that your fuel gauge is reading incorrectly, before considering changing the gauge, have your Pro-Line dealer's
Service Department or a qualified service professional remove the fuel sender and check to make sure that the
float is able to move up and down freely.

Fuel Water Separators

Depending on your selection of the various optional engine packages, your boat may be equipped with a fuel
water separator for each engine. However some engines come equipped with a built in fuel water separator.
Please refer to the owner's manual provided by your engine manufacturer for proper procedures. Check engine
specs.
If your engine package requires the installation of fuel water separators, they will be mounted on one of the
stringers or bulkheads in the bilge. There is one unit for each motor. The "spin on" filter cartridges should be
renewed every season at a minimum.
condensation. Therefore, the filter cartridges may need to be replaced more often depending upon usage and
conditions or if motors begin to run rough. When replacing the filter cartridges for the fuel water separators, coat
the rubber seal with a film of grease or oil to help prevent sticking.
Starboard
Engine Fuel
Pick-Up
Fuel Vent
Manufacturers
Label
Fuel tanks that are not kept full accumulate water faster due to
Located below the access pie installed
forward of the helm seat and aft of the console.
Fuel Sender
Hose
Fuel Fill
Fuel Fill Hose
Fuel Vent
20