Rear Panel; Remote Control - Strong SRT 5200 User Manual

3.2 Rear Panel

1. ANT IN
2. To Tv
3. S/PDIf (Coax.)
4. USb*
* USB connector of SRT 5205 on the front
5. Tv SCART
6. vCR SCART*
* Only available in SRT 5202 and SRT 5205
7. Audio l/R and video*: Connect your receiver with your TV set using an A/V cinch cable.
* Only available in SRT 5205
8. Power Cord

3.3 Remote Control

1.
2.
3. Pg+/Pg-
4. DvT/vCR
5. Info
6. vol+/vol-
7. mEnU
8. EXIT
9. pq
10. tu
11. oK
12. RECoRD
13. TImEShIfT
14. 0 ~ 9
15. EPg
16. RECAll
17. AUDIo
18. Tv/RADIo
19. fAv
20. fIlE
21. TTX
6
To connect an antenna for reception of broadcasting signal.
To connect a TV set or to connect an extra receiver.
To connect your receiver to digital audio amplifier.
Connects to USB device
To connect your receiver with your TV set using a SCART cable.
To connect your receiver with your VCR using a SCART cable.
Your receiver requires a voltage of 220 ~ 240 V AC (Auto-selectable),
50/60 Hz +/-5 %. Make sure to check the power specification before
connecting your receiver to the wall outlet.
Turns the receiver On/Standby
Mutes audio output of the receiver
Page up/down
To switch between TV and VCR mode
Shows the actual channel information
Volume up/down
Opens the main menu/In menu you will get one step back
Exits from the menu or sub-menu
Menu Off: Change channel to previous/next.
Menu On: Moves the cursor up/down.
Menu Off: Increases/decreases the volume level.
Menu On: Change settings for specific Menus
Menu On: Activates the highlighted menu item.
Menu Off: Displays the current channel list
No function
No function
Channel selection or value input
Shows the EPG (Electronic Program Guide) in TV mode
Back to previous shown channel
Sets the current audio channel to left, right or stereo
Toggles between TV or RADIO mode
Favourite group selection
No function
Shows Teletext on OSD (On Screen Display)
PART 1 • English
Fig. 4
Fig. 5