Specifications - Strong SRT 5200 User Manual

PART 1 • English
Problem
No response to remote
control
Forgotten channel lock code
Forgotten menu lock code
After moving the receiver
to another room you are no
longer able to receive
digital reception
The receiver switches off
automatically.
* Display and RCA connectors only at SRT 5205; **VCR Scart only at SRT 5202 and SRT 5205
A.2 SPECIfICATIonS
Demodulator
Demodulator: COFDM; 16/64-QAM
Transmission mode: 2K, 8K
video Decoder
Profile level: MPEG-2 MP@ML
Video resolution: 720 x 576 pixels (PAL),
720 x 480 (NTSC)
Decoding & Video Out: PAL & NTSC
Aspect ratio: 4:3, 16:9
Audio Decoder
MPEG MusiCam Layer II
Sampling rate: 32, 44.1, 48 kHz
Audio mode: Stereo, Joint Stereo,
Dual Mono, Mono
Tuner
Front End: DVB-T, UHF & VHF Tuner
Input frequency range: 174 ~ 230 MHz (VHF)
and 470 ~ 862 MHz (UHF)
Loop through frequency range:
47 ~ 862 MHz
Input signal level: -82 ~ -20 dBm
Possible cause
Receiver off
Handset not aimed correctly
Front panel obstructed
Hand set batteries exhausted
The aerial feed former new point may
come through a distribution system
which may reduce the digital signal
now received by the box.
Auto Standby function enabled.
multimedia
Video playback – MPEG-1 and MPEG-2
encoded (mpg)
Audio playback – MP3 and WMA formats
Picture view – JPEG format
memory and System
Flash memory: 1 MByte
SDRAM: 8 MBytes
Connectors
ANT IN: IEC Female
TO TV: IEC Male
TV SCART (RGB, CVBS)
VCR SCART* – Composite Video, Audio L/R
RCA Output** – Audio L/R &
Video Output
S/PDIF: coaxial output
USB port, max. 5 V/500mA
*only SRT 5202, SRT 5205; **only SRT 5205
What to do
Plug in and turn on plug
Aim handset at front panel
Check for obstructions
Replace handset batteries
Re-install channels to cancel
channel lock
Contact local Service Hotline or
send email to our Support via
www.strong.tv
Try a direct feed from the antenna
Disable auto standby. See section
5.3.8 for details.
15