GE TransNET 900 Reference Manual page 96

DCE or CTS Key device behavior (DEVICE command) 32
frequency zone to skip (SKIP command) 41
hoptime (HOPTIME command) 34
network address (ADDR command) 29
owner's message (OWM command) 37
owner's name (OWN command) 37
radio mode (see MODE command) 36
received data handling mode (BUFF command) 30
received data timeout value (RXTOT command) 40
receiver test frequency (RX command) 39
testing mode (SETUP command) 40
SETUP command (enter testing and setup mode) 40
Setup Radio Test (SETUP) 40
Show Clock-Synchronization Master Network Address (SHOW SYNC) 41
SHOW command (display power output) 41
SHOW CON Command (show virtual connection status) 41
Show Measured RF Transmit Power (SHOW PWR) 41
SHOW SYNC Command 41
Show Virtual Connection Status Command (SHOW CON) 41
Site selection 6
SKIP command (set/display frequency zone to skip) 41
Skip Radio Operating Zones (SKIP) 41
SLEEP command (display/set radio's sleep setting) 42
SLEEP command (transceiver sleep ON/OFF) 42
Sleep Mode 59
Spread spectrum, basic principles of 2
SREV Command 42
STAT command (list alarms) 43
Store-and-Forward (SAF) 4, 23, 27, 34, 40, 45, 52, 57
Store-and-Forward Services (SAF) Support Command 40
SWR (Standing Wave Ratio)
performance optimization 21
Synchronization qualifiers 46, 55
synchronization, check 8
T
Tables
accessories 5
alarm codes 47
antenna system gain vs. power output setting 13
DATA INTERFACE connector pin descriptions 70
LED status indicators 20, 46
troubleshooting 48
Tail-end link
Adding to Existing Network 3
cable wiring for, illustrated 19
illustrated 4
installation 18
Technical specifications 66–68
TEMP command (display internal temperature) 43
I-8 MDS TransNET Ref. Manual MDS 05-2708A01, Rev. F