Data Buffer Mode; Code [None, 1; Security Code; Csaddr [1-65000, None] - GE TransNET 900 Reference Manual

Seamless mode (
BUFF ON
message size is 256 characters or less. Enforcement of this rule is left up to
the user. If more than 256 characters are transmitted data delivery will not be
seamless and data may be lost.
Changes to the
BUFF
because the Master radio broadcasts the buffer setting for the entire network.
At Remote radios, the buffer setting may be read when the radio is in synchro-
nization with the Master, but it cannot be changed.

CODE [NONE, 1...255]

Security Code

The command is used to select or display the security/encryption
CODE
setting in the radio.
The default is CODE NONE
provides an extra level of security beyond that provided by the Network
Address ( ). The disadvantage is increased complexity in managing the
ADDR
network.
The command takes an argument
CODE
without an argument will display either
that security/encryption has been enabled, but the radio will not display the
security argument.
When a value is active, all radios in the system must use the same code
CODE
value. If the code value is not properly programmed, a Remote radio will not
synchronize with the Master.
CAUTION: Record the
later forgotten, and a unit is to be added to the system, all radios in the
network must be set to
CSADDR [1–65000, NONE]

Clock-Synchronizing Master Address

Used to specify the network address of a "Clock-Sync" Master station to
which this station will be synchronized. Also see
Page 29 and "Co-Located and Close-Proximity Masters" on Page 63
further details.
CTS [0–255]

Clear-to-Send Delay

The (clear-to-send) command sets or displays the timer value associated
CTS
with the CTS line response. The command parameter ranges from 0 to 255
milliseconds.
For DCE operation, the timer specifies how long to wait after the RTS line
goes high before asserting the CTS line. A timer value of zero means that the
CTS line will be asserted immediately following the assertion of RTS.
MDS 05-2708A01, Rev. F
) is intended only for applications where the
setting may only be made at the Master radio. This is
. Setting CODE
value and store it in a safe place. If the code is
CODE
and then reprogrammed to a new value.
NONE
MDS TransNET Ref. Manual
to a value other than
or
1...255, NONE
NONE or ACTIVE
"ADDR [1–65000]" on
NONE
. Entering
CODE
. ACTIVE means
for
31