Detailed Command Descriptions - GE TransNET 900 Reference Manual

Table 10. Operating Status—Display Only (Continued)
Command
XPRI
Details Page 44
XMAP
Details Page 44
XRSSI
Details Page 44
Table 11. Diagnostic and Test Functions
Command
KEY
Details Page 35
DKEY
Details Page 33
TX [xxxx]
Details Page 43
RX [xxxx]
Details Page 39
SETUP
Details Page 40
ZONE DATA
Details Page 44
ZONE CLEAR
Details Page 44

6.3 Detailed Command Descriptions

The essential commands for most applications are Network Address (
Mode ( ), and Baud Rate (
MODE
commands allows you to tailor the transceiver for a specific use, or to conduct
basic diagnostics on the radio. This section gives more detailed information
for the commands listed above in Section 6.2.
Most of the commands below can be used in two ways. First, you can type
only the command name (for example,
programmed data. Second, you can set or change the existing data by typing
the command, followed by a space, and then the desired entry (for example,
). In the descriptions which follow, allowable programming vari-
ADDR 1234
ables, if any, are shown in brackets [ ] following the command name.
28 MDS TransNET Ref. Manual
Description
Address of the primary Extended radio unit
(Extension).
Included Extended units in MODE X.
(Extensions and Remotes only).
Minimum RSSI level required to preserve
synchronization with a non-primary radio.
(Only meaningful when XPRI is not NONE)
Description
Enables the transmitter test.
(Must be in Setup mode. Details on
Turns off the transmitter test.
(Must be in Setup mode. Details on
Set/display transmit test frequency.
(Must be in Setup mode. Details on
Set/display receive test frequency.
(Must be in Setup mode. Details on
Enables Setup mode.
Times out after 10 minutes. Press "Q" to quit.
Zone data statistics
Clears the Zone Data log
). However, proper use of the additional
BAUD
) to view the currently
ADDR
MDS 05-2708A01, Rev. F
Page 40.)
Page 40.)
Page 40.)
Page 40.)
),
ADDR