GE TransNET 900 Reference Manual page 8

9.5 Using the Radio's Sleep Mode (Remote Units Only) ...... 59
Sleep Mode Example........................................................ 60
9.6 Low-Power Mode (LPM)-Master Enabled .................... 60
Setup Commands ............................................................. 60
Reading RSSI & Other Parameters w/LPM Enabled ........ 61
Power Consumption by HOPTIME and SAF Settings ...... 61
9.7 Low-Power Mode versus Remote's Sleep Mode ............ 62
9.8 Mobile Operation Support .............................................. 62
Introduction ....................................................................... 62
Operational Influences-Hoptime & SAF.......................... 63
9.9 MIRRORED BITS™ Protocol Support ........................... 63
9.10 Seamless Mode Emulation .......................................... 63
9.11 Full-Duplex Emulation ................................................... 63
9.12 Co-Located and Close-Proximity Masters .................... 63
Master Station Configuration............................................. 64
Antenna System for Co-Located Master Stations ............. 64
9.13 Security ........................................................................ 65
10.0 TECHNICAL REFERENCE .......................................66
10.1 Product Specifications-900 MHz ................................ 66
10.2 Product Specifications-2.4 GHz ................................. 67
10.3 Diagnostic Interface Connections (RJ-11) .................... 69
10.4 Data Interface Connections (DB-9F) ............................ 69
Pin Descriptions-RS/EIA-232 Mode ............................... 70
Pin Descriptions-RS/EIA-422/485 Mode ........................ 71
10.5 Board-Only Supplemental Data .................................... 72
Product Differences-Board-only vs. Standard ................ 72
Unit Dimensions................................................................ 72
Mounting Requirements.................................................... 73
10.6 User Configurable I/O Connections .............................. 73
Using the I/O Points with InSite™ NMS Software............. 75
Application Example-Digital I/O at a Remote ................. 75
10.7 dBm-Watts-Volts Conversion Chart .............................. 76
Copyright Notice
This manual and all software described herein are Copyright 2013 by GE MDS, LLC. All rights
reserved, including the right to correct any errors and omissions in this manual.
vi MDS TransNET Ref. Manual MDS 05-2708A01, Rev. F