Low-Power Mode Versus Remote's Sleep Mode; Mobile Operation Support; Introduction - GE TransNET 900 Reference Manual

9.7 Low-Power Mode versus Remote's Sleep Mode

The Low-Power Mode (LPM) puts Remote radios into an operational config-
uration similar to Sleep, but there are some important differences. Below is a
comparison of the two modes.
Table 25. Power-Conservation Modes Comparison
Sleep Mode
• Manual control by
Features
connected equipment
• Selective application of
Sleep control
• User determines length and
frequency of sleep periods
• Low latency
Benefits
• Low standby power,
 3 mA at 13.6 Vdc
• Greatest potential for power
savings

9.8 Mobile Operation Support

Introduction

Reliable mobile operation of Remotes is practical in areas covered by
multiple Master Stations within the same network—Master stations with the
same Network Address (
Remote must have several reliable Master stations with which to communi-
cate.
A "reliable" Master is defined as one, which consistently matches, or
exceeds, the Remote's standard for Minimum RSSI (
Initially, the Remote will favor Masters with signal strengths 10 dB greater
than the MRSSI threshold. This will allows for some signal degradation of the
new Master as the Remote travels.
When the average signal level from the currently-associated Master falls
below the user-defined
and seek an alternate Master with a reliable signal.
62 MDS TransNET Ref. Manual
). To make this type of service practical, the
ADDR
level, the Remote will become out-of-sync
MRSSI
Low-Power Mode
• Automatic radio-controlled timing
• Automatic sleep during absence of
directed traffic
• Network-wide implementation
through Master station
• Less complicated implementation
• Simple configuration
MRSSI
MDS 05-2708A01, Rev. F
).