GE TransNET 900 Reference Manual page 27

choose a mounting location that provides easy access to the connectors
on the end of the radio and an unobstructed view of the LED status
indicators.
Figure 10. Transceiver Mounting Dimensions
Figure 11 shows the four connectors on the transceiver and their functions.
Antenna
Figure 11. Interface Connector Functions
2. Install the antenna and antenna feedline for the station. Antennas should
be mounted in the clear and in accordance with the manufacturer's
instructions. Additional information on antennas and feedlines is
contained in Section
NOTE: It is recommended to mount the antenna be at least 10 feet (>3 meters) from the
radio, RTU, sensors and other components of the system to prevent RFI.
3. Connect the data equipment to the transceiver's
only the required pins for the application.
MDS 05-2708A01, Rev. F
6.63
(16.64 cm)
(Payload)
Diagnostic
(Communications)
3.4 on Page 9.
MDS TransNET Ref. Manual
Invisible place holder
Invisible place holder
Data Primary Power
(6–30 Vdc)
DATA
2.75
(7.0 cm)
1.62
(4.15 cm)
connector. Use
15