Table of Contents
Advertisement
cdr.sql
Chapter 7. Debug monitor
7.1 Initialization Information
During d evice start-up there will be some initialization information, the information can be judged
according to the device working condition. The following information is some commonly used
example for reference purposes only.
Now link status is speed: 100, duplex: FullDuplex
This line is the net port initialization information, device start-up will automatically detect the
speed of Ethernet,
speed: 100
network is not connected, you can not do automatically detection. The default speed is set to 100 Mbps
Network.
dsp[0] dtmf06 load ok!
dsp[1] metrec load ok!]
This is a DSP chip initialization information, the format is "dsp [number] function description,
loaded situation." Number start from 0. Function including
callerid and so on. If load successful then
failed.
voc channels: 64
The number of voice processing resources available, one DSP has 64 channels.
voc read num: 6
automtic
number of
Voice response resources have been loaded, -1 indicated that there is no voice.
voc num: 6
voc [0] len: 17760
.........
After the success of voice-loaded, display the total number and size of each audio file, in bytes.
The following is a list PCM signaling
pcm [0] ss7 link [0], ts = 16
pcm [1] ss7 link [1], ts = 16
ss7 [0] mailnum: 1 ch (1,32) start ...
ss7 [1] mailnum: 1 ch (33,64) start ...
Here is information on STUN
set stun server = [: 3478]
The following is CtiLnk development interface server startup information
CtiLnk enter ...
Mbps network,
FullDuplex
"load ok",
or else (like
NC-AD300E Manual
. If it is
speed: 10,
the network is 10 Mbps, If
voice, dtmf mfc,
metrec,
add [80]: 0x0! = 0xf073)
conference,
means load
- 50 -
Advertisement
Table of Contents
