NiceUC NC-AD300E User Manual page 37

NC-AD300E Manual
2. Transfer to FXO
The FXo
To forward calls to FXO. Trunk number will be used is decided by the selction in
Description, There are three to choose from, as below figure:
frist SpecifyLine, as shown below:
Designate a FXO line
Second, specifyLineRange, as shown below:
Specify a range, input the start number and end number of FXO lines
third, SpecifyLineGroups, as shown below:
The designated group of FXO, and the select of the lines in the group:
RoundInGroup: select the line one by one in turn, each time will select a different line.
SequenceInGroup, always selct the line from the beginning for each time call in. only busy
to select the next one.
- 37 -