NiceUC NC-AD300E User Manual page 26

Calling attributes, caller screening, caller display, called attributes, set the number of
properties, usually select the default value.
MfcVallDelay: When receiver number, if the number is passed by bit, will wait this value of
ms(second) for next bit. If longer than this time but did not receive next bit, then the number
receiving has been completed.
Usage pattern: usually choose "normal mode." "Signaling Collection" and "high-impedance
recording" in and line monitoring of the use of high barrier from the need for external devices can
be collected signaling, monitoring recording.
When the check the "ring-back does not pass through", the device will provide their own ring
back tone, rather than pass through the next level.
On the SS7 signaling parameters are as follows:
Link ID, the Link ID in this PCM
added before configuration the SS7 parameters.
CIC, the time slot number in each E1, This CIC number is the number of E1, number oftime slot in
this E1 will be automaticly increased . For example, CIC set to 0, then time slot 0-31 in this E1 will
be from 0 to 31; if the CIC set to 1, then the time slot 0-31 in this E1will be numbered from 32 to63
If the CIC set 2, then the time slot 0-31 in this E1 will be numbered from 64-95; and so on.
MaskTimeSlot: will mask this timeslot to be non-exist.
On the CSS1 sigaling parameters are as shows:
,
see description of SS7 link in later chapter, SS7 link should be
NC-AD300E Manual
- 26 -