Table of Contents
Advertisement
In the "SLC" parameter page, you can set the circuit gain and attenuation
Move the slider to the right to increase volume, move to the left to decrease. OutGain corresponds
to the voice heared by other side, inGain corresponding to the volume of this side.
The "line Part", you can set the volume for each line, such as:
After completion of editing, write to ROM and RAM to be effective immediately.
5.2.6 Call control
First need to group the same type of interface, as shown below:
Right click in the table, pop-up action menu, can add and delete. User Can also goes to "Data"
menu operation. Or use the toolbar Button
Once added, first select the "Line Type", then select line range (Note that the end value of
LineRange is excluded), at last select the rules for these LineType.
Rules including Length rules, number conversion rules and routing rules. Number conversion
rule can be applied to call in and call out. Each rule table can define multiple groups, each group there
are multiple rules.
Note that the call in and call out is base on the AD300E itself
5.2.6.1 Length Rules
When the AD300E is receving the caller ID, we need to determine the length of each number. In
NC-AD300E Manual
operation.
- 33 -
Advertisement
Table of Contents
