Terminal Connection - NiceUC NC-AD300E User Manual

2.Through Telnet program on the Ethernet.
FTP Server
Console
Console
terminal
But before use the Telnet,we need to know IP address of the device, and ensure the internet
smoothly.

4.1 Terminal connection

We usually use PC to debugging device,when connecting to device console port,it needs to
running a simulation software on PC, In Windows system, the commonly used "Super Terminal."
you can also use any other terminal software, recommended the use of SecureCRT.
Use of methods about "Super Terminal" can be found in Appendix II or other materials
When use console port,terminal parameter configuration as shown:
Baud rate
Data bits
Parity
Stop bits
Flow Control
Notes: Computer usually have two serial ports,COM1 and COM2,if it's out withUSB-Serial
port, then may be COM3,COM4,COM5 etc.please confirm the choice of the port is correct
It can be use Telnet service through Ethernet connection,in Windows system, point "Start" menu
Then choose "Run",and enter "address of IP" .you can also use other third-party software.such as
Secure CRT. Default of the telnet login name is admin ,password is nice.
Notes:at the same time ,console port and telnet connection only one,when the telnet
Connect ,the Console port will be limited .only when the telnet exit, console port
session can be restored . and through the Ethernet you may connect telnet only
one,if you have connected a telnet. Re-connect will be limited.
Telnet
Ehternet
AD300E
115200
8
None
1
None
NC-AD300E Manual
。 。 。 。
- 14 -