Conference Calling - ESI 600 User Manual

ESI Feature Phone operation
. . . to a voice mailbox
Transferring a caller to a mailbox to leave a message
1. While connected to an internal call, press TRANSFER, then press VOICE MAIL, and then press a
station key or dial an extension number.
2. You and the caller will be connected to that user's personal greeting. You may choose either to
hang up immediately or listen to a portion of the personal greeting (i. e., to assure yourself that you
have placed the caller into the correct mailbox).
Note: Regardless of when you hang up, the caller will hear the entire personal greeting. To insure the privacy
of the message, you will automatically be disconnected at the record tone.

Conference calling

To create a conference call:
1. Establish the first call.
1
2. Press CONF to place the call on hold.
3. Place a second call as you normally would.
4. Once connected to the second call, press CONF again to connect all of you together.
Notes: Repeat these steps to add each additional member to the conference.
A maximum of 16 members can be in a single conference.
If the newest added-on member does not answer, press his/her station key again or press FLASH to
return to the original conferees. If you place any incoming caller on hold or exclusive hold (see
"Hold/exclusive hold operation," page E.13), you can add that caller, as well, to the conference by
pressing CONF, retrieving the call from hold (or exclusive hold) and pressing CONF again.
(Continued)
1
If you're using an ESI Cordless Handset, use the TRANS/CONF/PRG key each time these instructions tell you to use CONF.
E.8
User's Guide