ESI 600 User Manual page 12

Introduction
60-Key Expansion Console connection
Notes: Your Installer or System Administrator must enable Expansion Console support for your extension
before you can use one or both Expansion Consoles.
The 60-Key Expansion Console can be connected to only a 48-Key Feature Phone.
If connecting both a 60-Key Expansion Console and a Second Expansion Console to a 48-Key Feature
Phone, see "Second Expansion Console connection," page A.9.
1. Unplug the line cord or Ethernet cable from your 48-Key Feature Phone.
If it's an IP Feature Phone II with a power supply plugged into it, unplug the power supply, too.
2. The 60-Key Expansion Console (right) includes a six-conductor
expansion cable. Connect one end of the expansion cable to the
appropriate connector on the bottom of the Feature Phone (below).
Then, connect the other end of the expansion cable to the 60-Key
Expansion Console.
3. To keep cabling out of the way, thread the expansion cable into the
slots on the bottom of the phone and 60-Key Expansion Console.
4. Program the keys on the 60-Key Expansion Console using the same
procedure as with the Digital Feature Phone (press PROGRAM 2).
5. If necessary, remove the clear plastic overlay from the keys on the
Expansion Console.
6. For maximum convenience, label the paper overlay to show how
the keys are programmed (your Installer or System Administrator can do this with ESI software).
7. Install the labeled paper overlay on the 60-Key Expansion Console.
8. Install the clear plastic overlay over the paper overlay, to protect it.
9. Use the provided Velcro
side of the 48-Key Feature Phone.
10. Plug the line cord or Ethernet cable back into your 48-Key Feature Phone.
If you unplugged a power supply in step 1, plug it back in, as well.
A.8
®
tape to attach the left side of the 60-Key Expansion Console to the right
To
headset
Handset
To 60-Key Line cord
Console to wall
Connectors on bottom of
48-Key Digital Feature Phone;
TAPI model shown
(TAPI)
to PC
User's Guide