ESI 600 User Manual page 13

User's Guide
Second Expansion Console connection
Notes: Your Installer or System Administrator must enable Expansion Console support for your extension
before you can use one or both Expansion Consoles.
If connecting only one Expansion Console to a 48-Key Feature Phone, see "60-Key Expansion
Console connection," page A.8.
The Second Expansion Console connects to the 60-Key Expansion Console and cannot connect
directly to the 48-Key Feature Phone (which is the only phone to which you can connect a 60-Key
Expansion Console).
1. Unplug the line cord or Ethernet cable from your 48-Key Feature Phone.
If it's an IP Feature Phone II with a power supply plugged into it, unplug the power supply, too.
2. The Second Expansion Console
expansion "Y" cable (right)
the back of the equipment so that the AC adapter is on
left and the end of the cable is on the right.
3. Connect the right end of the expansion "Y" cable to the
appropriate connector on the bottom of the 48-Key
Feature Phone (below).
4. Then, connect the expansion "Y" cable's middle plug to the 60-Key Expansion Console, the left
plug to the Second Expansion Console, and the AC adapter to an appropriate 110 VAC outlet to
provide power to the Second Expansion Console (above).
5. To keep cabling out of the way, thread the expansion "Y" cable into the slots on the bottom of the
phone and the two Expansion Consoles.
6. Program the keys on the two Expansion Consoles using the same procedure as with the Digital
Feature Phone (press PROGRAM 2).
7. If necessary, remove the clear plastic overlay from the keys on the two 60-Key Expansion Consoles.
8. For maximum convenience, label the paper overlay to show how the keys are programmed (your
Installer or System Administrator can do this with ESI software).
9. Install the labeled paper overlays on the two 60-Key Expansion Consoles.
10. Install the clear plastic overlays over the paper overlays, to protect them.
11. Use the provided Velcro
side of the 48-Key Feature Phone, and the right side of the 60-Key Expansion Console to the left
side of the Second Expansion Console).
12. Plug the line cord or Ethernet cable back into your 48-Key Feature Phone.
If you unplugged a power supply in step 1, plug it back in, as well.
1
It's physically identical to a 60-Key Expansion Console; consult your Installer if you have trouble determining which one it is.
2
This diagram shows the backs of the Expansion Consoles.
1
includes an
2
. Lay out the cable across
®
tape to attach the left side of the 60-Key Expansion Console to the right
To (TAPI)
headset to PC
Line cord Handset
To 60-Key
Console to wall
Connectors on bottom of
48-Key Digital Feature Phone;
TAPI model shown
Introduction
A.9