Power, Reset, And Keyboard Lock Buttons - HP NetServer LC 2000r Installation Manual

Chapter 2

Power, Reset, and Keyboard Lock Buttons

The control buttons shown in Figures 2-1 and 2-2 are described in the Table 2-1.
Table 2-1. Power, Reset, and Keyboard Lock Buttons and LEDs
Control/LED
This button turns the HP NetServer power On or Off, and if
Power On/Off/
available, also transitions the NetServer between Power On
Sleep Button
and sleep states. If sleep states are not available, then this
button only turns power On or Off.
The sleep states are NOS dependent and not available if your
NOS does not support power management based on the ACPI
(Advanced Configuration and Power Interface) standard.
Refer to "Applying Power to the HP NetServer" and "Sleep
States (ACPI)" later in this chapter.
This LED glows steady green when power is on, and goes
Power On/Off/
dark when the NetServer is powered off.
Sleep LED
If the NetServer is under ACPI control, this LED will flash
green on and off when in an inactive sleep state.
Reset Button Performs a system (hard) reset.
RESET
Keyboard Puts the NetServer in a locked mode, which locks the
Lock Button keyboard, if the NetServer was configured for keyboard lock
or Network Server mode in the Setup Utility.
This includes keyboard lock, power button lock, and video
blanking. The reset button is also disabled.
Keyboard This LED glows solid green when the HP NetServer's
Lock LED keyboard is locked, and is dark at all other times.
10
Controls, Ports, and Indicators
Description