HP NetServer LC 2000r Installation Manual page 37

Chapter 3
3. Press the power switch on the HP NetServer's control panel when
prompted by the operating system.
Normally, this completes the power-down procedure.
4. Disconnect the power cord from its power source.
5. To remove the bezel, pull the top of the bezel forward until it unsnaps, then
lift the entire bezel upward and away from the chassis. See Figure 3-6.
The bezel connects to the front of the HP NetServer chassis with two
snap-in connectors at the top front of the chassis and two metal tabs, which
fit into two slots on the bottom front of the chassis.
Figure 3-6. Removing the HP NetServer LC 2000 Bezel
CAUTION
To prevent damage to the covers, support the cover as you
remove it from the HP NetServer. The NetServer's covers can
be easily damaged.
Opening and Closing the HP NetServer
29