HP NetServer LC 2000r Installation Manual page 20

Chapter 2
Hot Swap Disk Drive Indicators
Each of the Hot Swap hard disk drives has two LED indicators, one for
operational status and one for activity status. Light pipes on each drive module
transmit light to the front from the LEDs on the inside rear of the hot-swap mass
storage cage. See Table 2-3 and Figure 2-3.
Table 2-3. Hot Swap Hard Disk Drive LED Indications
Status LED
Off: Disk not present, or not
connected to the cage
Green (solid): Disk present
Amber (flashing): Disk failure
predicted
Red (flashing): Disk failed
Red (solid): No +12 volt power
CD-ROM Drive
Activity Eject
LED Button
Flexible Disk Drive
Activity Eject
LED Button
12
Activity Status LED
Off: No disk activity
Green (flashing): Accessing disk
Green (solid for more than one
minute): Disk spinning up, or "hung"
R E S E T
Figure 2-3. Drive LED Indicators
Controls, Ports, and Indicators
DAT Tape
Drive (Optional)
Status
LEDs
Hot Swap
Hard Disk Drives
Status
LED
Activity
LED