Using The Setup Screens - HP NetServer LC 2000r Installation Manual

Chapter 10
Embedded LAN & SCSI Settings – Use this menu to set the embedded
NIC to enable, disable, or enable as a boot device (Boot ROM
Enabled). If the embedded NIC is enabled as a boot device, boot ROMs
for enabled SCSI devices cannot be loaded. This menu also
enables/disables the Wake-On-LAN feature.
Keyboard & Mouse Settings – Use this menu to set the parameters of
the keyboard, including NumLock, and set the PS/2 mouse to Auto
(detect)/Enabled/Disabled. Disabling the mouse frees up IRQ 12, but
prevents any installed PS/2 mouse from functioning.
Flexible Disk & IDE Settings – Use this menu to change the flexible
disk type and IDE settings of the HP NetServer's configuration. This
would include selecting the hard drive's characteristics, manually or
automatically, and selecting which drive would be the Primary Master
or Slave.
Processor/Memory Settings – Use this menu to select if the processor
module's serial number (if supported) will be read by firmware, enables
memory caching, and adds an extended memory gap in system address
space.
Security – Provides two submenus to choose from.
Power-On Password – Sets the administrator and user passwords,
setting system to require a password after booting.
The Administrator password must be set before setting the User
password. Once the administrator password is set, the administrator can
access and change all fields in the screens.
If the User password is set, the user may only change the system time,
date, and user password. The user may view all fields, but cannot alter
any of the settings.
Hardware Security – Sets the system parameters for input device
operation, including copying sensitive data and boot security.
Exit – Exit the Setup Utility by saving changes or exit without saving
changes, which reverts to previous settings.
When you exit, the HP NetServer reboots.

Using the Setup Screens

Online help explains the settings displayed on the Setup Utility screens.
Instructions are also provided for navigating between the screens and entering or
changing the setup data.
Configuring the HP NetServer
113