Removing Covers - Pedestal (Lc 2000) - HP NetServer LC 2000r Installation Manual

Chapter 3
24. Slide the HP NetServer into the rack.
25. To replace the front bezel, reverse the procedure by positioning the bezel
over the hinge pins at the front of the HP NetServer's chassis.
26. Press the down on the Blue Bezel Release tab to engage the hinge pins of
the bezel and then release it.
27. If the NetServer is not in a restricted-access area, tighten both slide
securing screws. See Figures 3-2 and 3-3.
28. Return the HP NetServer to normal operation.
Removing Covers – Pedestal (LC 2000)
Use this procedure to remove the bezel and covers (left & right) on the pedestal
version of the HP NetServer LC 2000.
If you are installing hardware options, you must remove the front bezel and
top cover. The hardware options include accessory boards, DIMMs, and an
additional processor.
If you are only installing hot-swap disk drive modules or a redundant
power supply, you do not need to remove the bezel or the covers.
WARNING
Do not operate the HP NetServer with its covers removed.
Always disconnect the power cord before removing any
covers, to avoid exposure to high energy levels that may cause
burns when parts are short-circuited by metal objects such as
tools or jewelry. Disconnect any telephone cables to avoid
exposure to shock hazard from telephone ringing voltages.
CAUTION
To prevent overheating, never operate the NetServer with its
covers removed. This includes the power supplies and Hot
Swap hard disks, which must be replaced or the opening
covered immediately (within 2 minutes).
1. If the HP NetServer is operating, log off all users and, if necessary,
back up files.
2. Follow instructions in your network operating system (NOS)
documentation to gracefully shut down all networking software and
applications.
28
Opening and Closing the HP NetServer