HP NetServer LC 2000r Installation Manual page 85

Chapter 7
10. Remove the processor module from the sealed bag.
11. Open the latches on top of the processor slot. See Figure 7-5.
If a processor is installed in the slot, the processor module will move up in
the slot where you can grasp it for removal.
12. Align the additional processor module over the secondary processor
module slot. See Figure 7-5.
13. Gently push down on the processor module until it seats.
14. Slide the retaining latches closed to completely seat the processor module
firmly in the connector. See Figure 7-6.
Figure 7-5. Installing the Processor
Installing Additional Processors
77