HP NetServer LC 2000r Installation Manual page 125

Chapter 10
NOTE To leave the pop-up menu without entering a password, press
the Esc key at any time.
8. Choose Yes and then press the Enter key.
The "Administrator Password is" field changes to "Set" and on the next
boot the HP NetServer will requests a password to access the Setup Utility.
9. If you want a password on boot up, you may skip the "User Password is:"
field and go directly to "Network Server Mode: [Disabled]" in Step 10.
10. If you want to enter a User Password, use the arrow keys to move to the
"User Password is:" field and repeat Steps 3-7 for the User Password.
11. Use the arrow keys to move to the "Network Server Mode: [Disabled]"
field.
12. Press Enter to toggle [Disabled] to "Enabled" in the Network Server Mode
field.
Setting this mode to Enabled will cause the HP NetServer to prompt for a
password when booting from a diskette or a CD-ROM, but will not require
a password when booting from a hard drive. The power-switch and
keyboard will remain locked until the password is typed.
13. To use the front panel keyboard lock button, use the arrow keys to move to
the "Keyboard Lock [Disabled]" field.
14. Press Enter to toggle [Disabled] to "Enabled" in the Keyboard Lock
[Disabled] field.
Setting this feature enables the keyboard lock button on the front bezel of
the HP NetServer. Once enabled, pressing the keyboard lock button will
lock the keyboard and mouse until the password is typed. You must set the
password before enabling this feature.
15. To add video blanking to the password on boot, use the arrow keys to
move to the "Video Blanking [Disabled]" field.
16. Press Enter to toggle [Disabled] to "Enabled" in the Video Blanking
[Disabled] field.
Setting this feature only provides a blank screen on the HP NetServer's
Monitor, when the Keyboard Lock or Network Server Mode are also
enabled. The screen remains blank until the password is typed and only
applies to the monitor connected to the HP NetServer's embedded video
connection. As with the other features the Video Blanking is dependent
upon, you must set the password before enabling this feature.
Configuring the HP NetServer
117