HP NetServer LC 2000r Installation Manual page 82

Chapter 7
6. Verify the processor speed and FSB setting, before installing the second
processor module. See Figures 7-1 and 7-2, and Tables 7-1 and 7-2.
Both processor modules must have the same clock speed, cache size, FSB
speed, and product number.
7. If installing two new processor modules, set the switches accordingly.
Use a small, flat-blade screwdriver or similar tool.
Shaded rectangle
represents the
position of slide
switch.
Table 7-1. Configuration Switch Settings
FSB Switch Setting
SW8 – Off
(133 MHz Bus)
533 MHz
600 MHz
667 MHz
733 MHz
74
Open = Off Closed = On
Rear of HP NetServer
Figure 7-2. System Switch and Settings
Processor Speed Settings
(Multiple
of FSB) SW1 SW2
4.0X ON OFF
4.5X ON OFF
5.0X ON OFF
5.5X ON OFF
Installing Additional Processors
2 Processor Speed (Bit 1)
3 Processor Speed (Bit 2)
4 Processor Speed (Bit 3)
5 Clear Configuration
6 Clear Password
8 FSB Speed (133/100 MHz)
SW3 SW4
ON ON
ON OFF
OFF ON
OFF OFF