Continuing With The Rack Installation Process - HP NetServer LC 2000r Installation Manual

Chapter 13
2. Press down on the blue Bezel Release tab shown in Figure 13-12.
Figure 13-13. Attaching the Bezel to the NetServer
3. Press the bezel onto the front of the HP NetServer and release the Blue Tab
to engage the hinge pins. See Figures 13-12 and 13-13.
4. Swing the open bezel to the right to engage the catch and close the bezel.

Continuing with the Rack Installation Process

After you install the HP NetServer in the rack, refer to the HP Rack Installation
Road Map to continue with the process of installing and configuring your HP rack
system.
160
Alternative Rack Mounting